Instructions For The Brushless Speed Controller (Esc) 50 040 4026 - Carson X-18 Serie Manual De Instrucciones

Functions
∆ Forward: Pull the throttle lever on the radio, the car goes forward.
∆ Brake: Push the throttle lever to brake the car.
∆ Reverse: Push the throttle lever forward, when the car is not run-
ning. Then the car will run backward. Speed can be proportionally
controlled.
∆ The LED indicator is always on during forward, reverse and brake
GB
mode. When the ESC is not working and the car stops, the LED
indicator is off. When the radio communication is interrupted, the
LED indicator on the ESC flashes.
e. Instructions for the Brushless Speed Controller (ESC)
50 040 4026
Features
• Running modes: Forward mode and forward/backward mode.
• Proportional ABS brake function, with 4 steps of maximum brake
force adjustment, 8 steps of drag-brake force adjustment.
Adjustments
1. Connect the ESC, motor, receiver, battery
and servo according to the following
diagram.
Positive (+) and negative (-) wires of the ESC are connected with the
battery pack. A, B and C are connected with the motor wires. The
control cable of the ESC (wires in black, red and white colour) is
connected with the throttle channel of the receiver (usually CH2).
The A, B, C wires of the ESC can be connected with the motor wires
freely (without any order). If the motor runs in the opposite direction,
please swap any two wire connections.
The "SET" button is used for programming the ESC.
2. Throttle range setting
(throttle range calibration)
In order to make the ESC fit the throttle range of your
transmitter, you must calibrate it for the following cases;
otherwise the ESC cannot work properly.
1) Begin to use a new ESC
2) Begin to use a new transmitter
3) Change the settings of neutral position of the throttle lever, the
ATV or EPA parameters, etc.
24 CARSON X-18 50 040 40 25 + 50 040 40 26
Warning:
∆ This ESC is not waterproof. Water should be avoided. lf water goes
into it, take down the power switch immediately.
∆ It's dangerous to touch the motor after running, as it emits heat
during running, and the cooling plate is hot after running.
• Different options of start modes (also called "punch") from "soft" to
"aggressive".
• Splash proof and dustproof
Brushless motor
A, B, C motor wires
Input TH channel
(CH2)
Switch
Receiver
Servo plugged into
steering channel (CH1)
Black power wire
(battery negative)
Red power wire
(battery positive)