Assembly - Briggs & Stratton Troy-Bilt PW101-2010 Manual Del Operador

Assembly

Read entire operator's manual before you
attempt to assemble or operate your new
pressure washer.
Your pressure washer requires some assembly and is
ready for use after it has been properly serviced with
the recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer
helpline at (888) 611-6708. If calling for assistance,
please have the model, revision, and serial number
from the identification label available.
Unpack Pressure Washer
1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Ensure you have all included items prior to
assembly.
Items in the carton include:
• Main Unit with Cleaning Tank
• Handle
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Plastic Accessory Tray
• Oil Pouch
• Engine Operator's Manual
• Parts Bag (which includes the following):
• Operator's Manual
• Bag of 5 Multi–Colored Quick Connect Spray
Tips
• Handle/Accessory Tray Fastening Hardware Kit
(which includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Tree Clips (4)
To prepare your pressure washer for operation,
you will need to perform these tasks:
1. Attach handle and accessory tray to main unit.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.
4. Connect high pressure hose to spray gun and
pump.
5. Connect water supply to pump.
6. Attach nozzle extension to spray gun.
7. Select/attach quick connect spray tip to nozzle
extension.
6
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports.
A
2. Insert handle carriage bolts (B) through holes from
inside of unit and attach a plastic knob (C) from
outside of unit. Tighten by hand.
NOTICE By loosening both knobs to the unthreaded
middle section of the attachment bolt, the upper handle
can fold forward to store flat atop the cold engine.
DO NOT fold the handle down while the engine is hot.
3. Place accessory tray (D) over holes (E) on handle
(viewing from front of unit). Push the tree clips
(F) into the holes until they sit flat against the
accessory tray.
D
ÄÉ»ÈÊ ÃËÂÊ¿ ¹ÅÂÅÈ»º ÉÆÈ·Ï Ê¿ÆÉ ·Äº Åʾ»È ÉËÆÆ¿»º
·¹¹»ÉÉÅÈ¿»É ¿Ä ÉÆ·¹»É ÆÈÅÌ¿º»º ¿Ä ·¹¹»ÉÉÅÈÏ ÊÈ·Ï
»» ÅÍ ÊÅ É» ¹¹»ÉÉÅÈÏ È·Ï
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
• Refer to engine operator's manual and follow oil
and fuel recommendations and instructions.
NOTICE Any attempt to crank or start the
engine before it has been properly filled with the
recommended oil will result in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTICE Check oil often during engine break–in. Refer
to engine operator's manual for recommendations.
B
C
F
E
www.troybilt.com