Saving A Position; Saved Position; Aligning Height Display; Changing Height Display Unit - vitra. CDS Manual De Instrucciones

Saving a position

EN
Four different table heights can be saved to memory.
1. Move with the "Up" or "Down" button to the desired
height.
2. Then press the "Memory" button ("S" is shown in the dis-
play) and then one of the "Position" buttons 1 – 4 ("S 1", for
example, appears in the display).
The procedure is confirmed with a double click sound and
after approximately 2 seconds the current table height is
shown in the display again.

Saved position

Press and hold one of the desired saved position buttons
(e.g. « 2 ») until the table stops of its own accord.
If the saved position button is released before the stop posi-
tion is reached, the desk will remain in the current position.
22

Aligning height display

If the displayed height does not agree with the actual
height of the table top, the display can be corrected in the
following way:
1. Press the "Memory" button and then release it.
2. Press the "Down" button for approx. 5 seconds until the
height display begins to flash.
3. Measure the table height and enter the measured value
using the "Up" or "Down" button.
4. Confirm the entry by briefly pressing the "Memory" button.
Only the display will change.

Changing height display unit

In order to change the units (metric or imperial) for height
display, proceed as follows:
1. Press buttons
"1", "2" and "Up" at the same time for approx.
3 – 5 seconds until
(x represents a number - if "S 5" is already displayed pro-
ceed with point 3.)
2. Press the "Up" or "Down" button until the display shows
"S 5".
3. Confirm with the "Memory" button.
the display shows "S x".