Restore Defaults - HP Cricut Imagine Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

If the cut was successful in staying inside the printed lines, click the
select button. If the cut was outside of the printed lines, select re-
peat to run the test again.
If the cut does not fall within the calibration test image line after run-
ning the blade calibration 3 times, you can try to tune the calibration
manually using the Advanced calibration screen.
note: It is strongly recommended that, prior to using the advanced
calibration controls, you contact Customer Care for assistance. They
will be able to give you instructions about each of the controls in this
area, and direct you how to use them.
To reach the Advanced screen follow these instructions:
• Click the Blade button in the Calibration section of the
Settings screen.
• Hold the top button on the left side of the screen.
• Click start Calibration.

restore Defaults

This control will set your Cricut Imagine
back to its factory settings,
removing any calibration changes you have made previously.
SETTInGS
33

Publicidad

Tabla de contenido
loading

Tabla de contenido