Troubleshooting - HP Cricut Imagine Manual De Instrucciones

troUBLesHootInG

tIP: For our complete list of frequently asked questions, plus the latest up-
dates to the User Manual, visit www.cricut.com.
Problem: The cutting mat won't load when I click Go! and try to feed it into
the machine.
+ solution 1: Try pushing the cutting mat slightly into the roller bar as you
click Go!
+ solution 2: Apply constant, gentle pressure to the mat as you click Go!
+ solution 3: Reset the printer by raising the ink access door and then
lowering it back into place.
+ solution 4: Turn the Cricut Imagine
attempt to load the machine.
Problem: The cutting mat didn't load when I clicked the Go! key.
+ solution 1: Your Cricut Imagine
didn't pull it in. Follow the on-screen instructions to retry to load the mat.
+ solution 2: Apply slightly higher pressure and try to reload the mat by
pressing Go! or the Play button.
Problem: The blade is not cutting all the way through the paper.
+ solution 1: Use the Multi-Cut function in the Project Preview screen to
allow for multiple cuts along the same cutting lines.
+ solution 2: Increase the cut pressure in the Project Preview screen.
+ solution 3: The blade depth may need to be adjusted, particularly if you
are trying to cut through thicker materials.
+ solution 4: The cutting blade may have become dull and needs to be
replaced. Refer to the replacing the Cutting Blade section on page 20.
Problem: The paper lifts off the mat as the Cricut Imagine
+ solution 1: Make sure you press the paper firmly onto the cutting mat
when setting up the cut.
+ solution 2: Rinse the mat with water while gently rubbing off the paper lint
on the mat. Let the mat thoroughly dry before attempting to re-use the mat.
34 TRoUBLESHooTInG
off, and then turn it back on and
™
thought that it loaded the mat, even if it
™
machine is cutting.
™