CAME ZL56 Manual De Instrucciones página 11

Activating the remote control
Connect the antenna with the RG58 cable to the apposite terminals on the board.
Connect the radiofrequency card to the electrical board AFTER SHUTTING OFF THE POWER (or disconnecting the batteries).
N.B.: The circuit board recognizes the readiofrequency card only when it is running in electrical power.
WARNING! Can memorise up to a maximum of 24 transmitters that have different codes.
Note: each transmitter that has a different code, may be duplicated for "n" transmitters (of the same series), except for the ATOMO tran-
smitter.
Activating the (2-7) sequential command
Keep the ENC/RADIO pressed on the circuit board. The led indicator will fl ash.
press the transmitter button (T1) to be memorised. The led indicator will stay on to confi rm memorisation.
Activating the (2-3P) partial opening command
First, keep the ENC/RADIO button pressed (the led indicator fl ashes) and then press the OP/CL button on the control board.
Press the (T2) button of the transmitter you wish to memorise. The signalling LED stays on to signal the memorisation has taken place.
Deleting all of the memorised radio users
Set DIP switches 1 and 2 to ON (the signalling LED, starts to fl ash), keep the ENC/RADIO button pressed for 5 seconds (the signal-
ling led starts to fl ash quickly and stays on to signal that deletion has taken place).
Set the DIP switches back to OFF.
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.