Buttonhole - Baby Lock Zest BL15B Instrucción Y Guia De Referencia

q
z x
(C)
(B)
c v
m
w e
r
(A)
n
b

Buttonhole

q Pattern selector:
w Presser foot:
e Thread tension dial: 1 to 5
r Stitch length:
NOTE:
• Make a test buttonhole on a sample
duplicating the fabric, interfacing and
seams of the actual garment.
• Place the button on the fabric sample and
mark the top and bottom to determine the
position of buttonhole.
• Use interfacing on stretch fabrics.
z Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the
buttonhole marking running toward you.
x Move the slider (A) toward you so that the top
mark (C) on the slider meets the start mark (B).
Line up the markings on the foot with the top
mark on the fabric.
NOTE:
The scale on the slider is engraved in
centimeters.
c Set the pattern selector dial at "
Sew forward until you reach the front marking
of your buttonhole.
Stop sewing on the left with the needle in the
up position..
v Set the pattern selector dial at "
Sew 5 stitches. Stop sewing on the right with
the needle in the up position.
b Set the pattern selector dial at "
Sew until you reach the back marking of the
buttonhole.
Stop sewing on the right with the needle in the
up position.
n Set the pattern selector dial at "
Sew a few bartacks and raise the needle from
the fabric.
Set the pattern selector dial at straight sewing.
Sew a few locking stitches.
m Remove the fabric from the machine and
cut the sewing thread. Insert a pin inside the
bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
42
(BH)
Sliding buttonhole foot
(0.5–1)
".
".
".
".