Tabla de contenido
Publicidad
q
w
t
Sewing Buttons
e
q Pattern selector:
w Presser foot:
e Thread tension dial: 3 to 7
r Stitch length:
r
t Darning plate
Attach the darning plate.
Match the holes of button to the horizontal slot of
the presser foot.
Adjust the stitch width so the needle will enter the
left hole of the button.
Lower the foot to place the button in place.
Check to see if the needle enters into the holes in
the button by turning the handwheel by hand.
Sew about ten (10) stitches.
To strengthen the shank, cut the threads leaving
about 4˝ (10 cm).
Bring the needle thread down through one of the
holes in the button and wind it around the shank.
Bring the needle thread to the wrong side (bottom
side) and knot.
After button sewing is completed, remove the
darning plate.
40
C
Zigzag foot
Any
Publicidad
Tabla de contenido
