Service; Accessories - SICK LSI 101 Manual Del Usuario

GB
* If the PLS front screen gets dirty clean it with a soft cloth
and plastic cleaner!
** System error: See section 7.2, Service!
= LED lit
1 Hz = LED flashing slowly
»4 Hz = LED flashing rapidly
= Output switches to high
= Output switches to low
= Output is constant low
»4 Hz = Output alternates between high and low

7.2 Service

The LSI is maintenance-free on account of its fully electronic
design. In case of faults, an initial diagnosis can be made on
the basis of the LED information presented under 7.1. Also
refer to the information in section 7.2, "Maintenance", of the
PLS Operating Instructions. Authorised personnel (see note in
the PLS and LSI Technical Descriptions) have access to an
extensive diagnostic system by means of the supplied user
software.
If you have any further questions please refer to your local
SICK office or contact the
SICK Service Hotline: +49 7681 / 202 - 3134

8. Accessories

For a list of the suitable cable sets for PLS cabling to the LSI
refer to the PLS or LSI Technical Description. The sections in
those documents headed "Selection table for PLS/ LSI" list all
the articles necessary to ensure the correct use of the
equipment.
150
© SICK AG · Industrial Safety Systems · Germany · All rights reserved
8 008 308/M848/06-05-02 Operating Instructions · LSI
LSI