Attach Wall Plate
STEP 2C
Steel Stud Anchor Kit (not included)
CAUTION:
Avoid potential personal injuries and property damage!
●
Studs must be at least 2x4 in. / 25 ga.
●
If back side of wall is unfinished, drywall must be installed to a minimum of one stud left and right of the stud(s) being used to install the mount
●
Drywall must be a minimum of 1/2 in. (13 mm) thick on each side of the studs, and a minimum clearance of 1 ⅞ in. (48 mm) behind the wall is required
●
Pilot holes MUST be drilled to a depth of 1 in. (26 mm), using a 1/2 in. (13 mm.) diameter drill bit
●
This product must be centered on the studs
●
Stud type and structural strength must conform to the North American Specification for the Design of Cold-Formed Steel Structural
Members [362 S 125 18, C-Shape, S - Stud Section]
●
Drywall must be secured to studs with screws 12 in. (304.8 mm) on center
14
- Contact Customer Service at 1-855-734-7805 t
1/4-20 Snap Toggle BB
S1 x4
Steel Stud Installation
o inquire about the additional hardware.
1/4-20 x 1¾ in.
S2 x4
1/4 in.
S3 x4