Programming - hager S145-22X Manual De Instalación

GB

3. Programming

CAuTIon: during recognition programming,
the product to be programmed for use with
the control panel does not need
to be placed next to it. In fact, we recommend
you place the product at a short distance
from the control panel (at least 2 m away).
1. Change the control panel to installation
mode if necessary by pressing the
following sequence on the control panel
keypad or the hardwired control interface
remote keypad:
master
code
then:
engineer
installer code
2. Programme the detector as follows:
CAuTIon: the detector number is automatically allocated by the control panel during
programming.
"detector X"
then
10 s max.
Press and hold the
#
Press then
*
"test" button until
on the control
the control panel
panel keypad
responds
CAuTIon: the control panel indicates there is an error by emitting 3 short beeps.
When this happens programming should be carried out again.
70
"group?"
"time delay?"
*
to or
The control panel The control panel
waits for a group waits for the time
to be chosen (from delay to be chosen.
1 to 4)*. Choose 0: immediate
the groups by 1: delayed
pressing the The time delay is
corresponding chosen by pressing
numeral on the "0" or "1" on the
control panel keypad control panel keypad
* Depends on the type of the control panel
"beep, detector X,
group Y immediate
(or delayed)"
The control panel
gives a voice
message to
confirm