Configuration - hager S145-22X Manual De Instalación

4. Configuration
In factory configuration, the movement
detector is configured in Discrete pre-alert
(for the reactions of the system see the
control panel installation guide).
It is possible to modify the level of alarm
using the following sequence of
parameter setting:
Configuration example: setting the
detector for an alarm level when a prealarm
is triggered: Parameter n° 5, Parameter
value 2.
Sequence of
Parameter n°
parameter setting 5
Indicator lamp
for
programming it
Indicator lamp
about 10 sec.
for programming
not lit
sequence
To start the Press 5 times
sequence depending
press and on the required
hold the parameter
button until the number
LED indicator
lamp goes out
5
Start Press 5 times Press
to select once to
the alarm accept
level selection
71
Alarm level Parameter value
Intrusion 1
Prealarm 2
Deterrence 3 (factory setting)
Warning 4
about
5 sec.
Press and Press 1 to 4 To end the
hold until the times depending sequence press
LED on the required and hold the
indicator parameter value button until the
lamp briefly LED indicator
goes out lamp goes out
2
about
2 sec.
Press 2 times End
to select
the prealarm
level
GB
about 10 sec. about
2 sec.
LED indicator
lamp lit =
correct
configuration