Indirect Measuring (Pythagoras) - Stanley FatMax TRU LASER TLM200 Manual De Empleo

displayed. Pushing the CLEAR/OFF - key {A, 5}
GB
undoes the last step.
Areas and volumes can be added / subtracted in
exactly the same manner.
Area
Press AREA/VOLUME/INDIRECT MEASUREMENT -
key {A, 3}. The corresponding symbol {B, 5} appears
in the display. The first side to be measured flashes
on the display. Take the two measurements, the
result will be displayed in the main line.
Volume
Press AREA/VOLUME/INDIRECT MEASUREMENT -
key {A, 3} twice. The corresponding symbol {B, 5}
appears in the display. The first distance to be
measured flashes on the display. When 3 measure-
ments have been taken the result will be displayed in
the main line.

Indirect Measuring (Pythagoras)

The device can calculate distances using a two point
Pythagoras' theorem. This method is useful when the
distance to be measured is difficult or dangerous to
access.
• Make sure you strictly follow the sequence of the
measurements
• All target points need to be vertically or horizon-
tally in the same plane
Functions
• Best results can be expected if the device is
turned around a fixed point.
• It is possible to use the "Minimum/maximum
measuring" by pressing the ON/MEASURING -
key {A, 1} longer. The minimum value is used for
the measurements perpendicular towards the
target.
See figure {I}
Press the AREA/VOLUME/INDIRECT MEASURE-
MENT - key {A, 3} three times. The Corresponding
symbol {B, 6} appears in the display. The distance to
be measured will flash in the display. Take the neces-
sary measurements. The result and the single
measurements appear on the display.
Right angle is necessary for the second
measurement - use "Minimum/maximum
measuring" as explained.
4
Stanley TLM 200 1.0.0 gb