Location Requirements - Maytag MVW18CSAGW0 Instrucciones De Instalación

LOCATION REQUIREMENTS
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed in a basement, laundry room, or
recessed area. See "Drain System."
Companion appliance location requirements should also be
considered.
iMPORTANT: Do not install or store the washer where it will be
exposed to the weather. Do not store or operate the washer in
temperatures at or below 0°C (32°F). Some water can remain in
the washer and can cause damage in low temperatures. Proper
installation is your responsibility.
You will need:
[] A water heater set to 49°C (120°F).
[] A earthed electrical outlet located within 1.2 m (4 ft.) of
power cord on back of washer. See "Electrical Requirements."
[] Hot and cold water faucets located within 1.2 m (4 ft.) of hot
and cold water fill valves on washer, and water pressure
of 138-690 kPa (20-100 psi). A pressure reduction valve
should be used in the supply line where inlet pressure
entering the building exceeds 690 kPa (100 psi) to avoid
damage to the washer mixing valve.
[] Single washer installations require 300 mm (12") minimum
risers to provide an air cushion and avoid noise and damage
to valves.
[] A level floor with maximum slope of 25 mm (1 ") under entire
washer. Installing on carpet is not recommended.
[] Floor must support washer's total weight (with water and load)
of 143 kgs (315 Ibs).
[] A floor drain under the bulkhead. Prefabricated bulkheads
with electrical outlets, water inlet lines, and drain facilities
should be used only where local codes permit.
Recessed Area or Closet Installation
This washer may be installed in a recessed area or closet.
The installation dimensions shown are the minimum spaces
allowable. Additional spacing should be considered for ease of
installation and servicing. Companion appliance spacing should
be considered.
Minimum installation spacing
356 rnm
114" max.) _ ...... ::
.............. ,........
25 mm
(1")
25 mm
(1")