Location Requirements; Location Of 10-Character Said Code On Wi-Fi Module - Maytag MAT20PDFGW Instrucciones

LOCATION REQUIREMENTS

Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed in a basement, laundry room,
or recessed area. See "Drain System."
Companion appliance location requirements should also be
considered.
IMPORTANT: Do not install or store the washer where it will
be exposed to the weather. Do not store or operate the washer
in temperatures at or below 0°C (32°F). Some water can remain
in the washer and can cause damage in low temperatures.
Proper installation is your responsibility.
You will need:
n A water heater set to 49°C (120°F).
n An earthed electrical outlet located within 1.2 m (4 ft) of
power cord on back of washer. See "Electrical Requirements."
n Hot and cold water faucets located within 1.2 m (4 ft) of hot
and cold water fill valves on washer, and water pressure
of 138 kPa–690 kPa (20 psi–100 psi). A pressure reduction
valve should be used in the supply line where inlet pressure
entering the building exceeds 690 kPa (100 psi) to avoid
damage to the washer mixing valve.
n Single washer installations require 300 mm (12") minimum
risers to provide an air cushion and avoid noise and damage
to valves.
n A level floor with maximum slope of 25 mm (1") under entire
washer. Installing on carpet is not recommended.
n Floor must support washer's total weight (with water and load)
of 143 kg (315 lbs).
n A floor drain under the bulkhead. Prefabricated bulkheads
with electrical outlets, water inlet lines, and drain facilities
should be used only where local codes permit.
Recessed Area or Closet Installation
This washer may be installed in a recessed area or closet.
The installation dimensions shown are the minimum spaces
allowable. Additional spacing should be considered for ease of
installation and servicing. Companion appliance spacing should
be considered.
Minimum installation spacing
356 mm
(14" maximum)
356 mm
(14" max.)
127 mm
(5")
127 mm
(5")
25 mm
(1")
LOCATION OF 10-CHARACTER
SAID CODE ON WI-FI MODULE
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
If a Wi-Fi Module has been purchased from a dealer or an
authorized service company, the Wi-Fi Module will be located
behind the Fascia Panel.
1. Remove the two screws to allow the Fascia Panel to be
rotated outward from appliance.
76 mm
(3")
406 mm 457 mm
(16") (18")
25 mm
(1")
76 mm
(3")
25 mm
(1")
WARNING
310 cm
2
(48 in )
2
155 cm
2
(24 in )
2
9