Publicidad
NOTES FOR INSTALLATION
EN
NOTE:
2018 Forward F-150
Step 1
- If the vehicle is not equipped with a 30 amp fuse at location F24, but terminals are present in the cavity, install the supplied fuse
(item B), reverse steps 1-4 to reassemble the battery junction box and then complete the remaining trailer brake control module
- If the vehicle is not equipped with a 30 amp fuse at location F24, and no terminals are present in the cavity, proceed to the repair
2018 Forward F-150 Battery Junction Box Jumper Harness Addendum
Step 5
Step 6
Step 8.
Step 10
Step 11
IMPORTANT: For proper operation, the battery junction box positive battery cable nut must be torqued to
Step 12
CAUTION:
properly, then DO NOT operate your vehicle until corrections are made.
CAUTION:
functions DO NOT operate properly, DO NOT operate your vehicle until corrections are made.
NOTE:
The message center in the instrument cluster will display "TBC FAULT" if it is receiving communications from the TBC module,
Trouble Codes (DTCs) stored in the TBC module, follow these steps to verify and/or modify the TBC module programmable
parameter in the Instrument Cluster (IC) using the Integrated Diagnostic System (IDS) or Ford Diagnostic and Repair System
F-150
©
5/52
SKFL3J-19H332-AC
Copyright Ford 2018
Publicidad
