Tabla de contenido
Publicidad
Instale las ruedas (cont.)
Panel interior - Utilizando tornillos del #8-32 x 3/8", instale dos ruedas en el lado
del soporte de suspensión que está hacia el panel exterior.
9.
Install the Door Panels
Top Track
Rail supérieur
Carril superior
Roller/Rouleau/Rueda
Inside Rail
Rail intérieur
Riel interior
Inside Panel
Panneau intérieur
Panel interior
Bottom Track Leg
Pied de rail inférieur
Pata del carril inferior
Inside of Bath/Shower
Intérieur de baignoire/douche
Interior de la bañera/ducha
NOTE: Perform these installation steps from outside the bath/shower.
Install the Inside Panel
Lift the inside door panel with the rollers facing away from you.
Position the rollers on the inside rail of the top track.
Position the bottom of the door panel in the bottom track guide.
Check the panel for proper alignment and smooth operation. Adjust as needed
(directions below).
After adjusting, align the inside panel with the wall jamb on the showerhead side
of the bath/shower.
Adjusting the Rollers
Remove the door panel.
Remove the roller screw(s) from the roller(s).
Move the roller(s) to another hole in the hanger bracket.
Thread the screw(s) into the roller(s) and tighten.
Sterling
Outside Rail
Rail extérieur
Riel exterior
Outside Panel
Panneau extérieur
Panel exterior
Inside of Bath/Shower
Intérieur de baignoire/douche
Interior de la bañera/ducha
17
Top Track
Rail supérieur
Carril superior
Roller
Rouleau
Rueda
1063219-2-B
Publicidad
Tabla de contenido
