Electrical Hazards; Fire Hazards; Explosion Hazards - Generac GT-530 El Manual Del Propietario

carbon monoxide poisoning symptom is
experienced, move into fresh air and immediately
seek medical attention.
• This generator is designed for outdoor installation
ONLY. Never operate the generator inside any
garage or other enclosed space.
1.2.3— Electrical Hazards
• All generators covered by this manual produce
dangerous electrical voltages and can cause fatal
electrical shock. Utility power delivers extremely
high and dangerous voltages to the transfer switch,
as does the standby generator when it is in
operation. Avoid contact with bare wires, terminals,
connections, etc., while the unit is running. Ensure
all appropriate covers, guards and barriers are in
place, secured and/or locked before operating the
generator. If work must be done around an
operating unit, stand on an insulated, dry surface to
reduce shock hazard.
• Do not handle any kind of electrical device while
standing in water, while barefoot, or while hands or
feet are wet. DANGEROUS ELECTRICAL SHOCK
MAY RESULT.
• The National Electrical Code (NEC) requires the
frame and external electrically conductive parts of
the generator to be connected to an approved
earth ground. Local electrical codes also may
require proper grounding of the generator electrical
system.
• After installing this home standby electrical system,
the generator may crank and start at any time
without warning. When this occurs, load circuits
are transferred to the STANDBY (generator) power
source. To prevent possible injury if such a start
and transfer occur, always set the generator to the
OFF mode, remove the 7.5A fuse from the
generator control panel, and disconnect the battery
before working on equipment.
• In case of accident caused by electric shock,
immediately shut down the source of electrical
power. If this is not possible, attempt to free the
victim from the live conductor. AVOID DIRECT
CONTACT WITH THE VICTIM. Use a
nonconducting implement, such as a dry rope or
board, to free the victim from the live conductor. If
the victim is unconscious, apply first aid and get
immediate medical help.
•
Never wear jewelry when working on this
equipment. Jewelry can conduct electricity
resulting in electric shock, or may get caught in
moving components causing injury.
Owner's Manual for 50 Hz Air-cooled Generators
Safety Rules & General Information
1.2.4— Fire Hazards
• For fire safety, the generator must be installed and
maintained properly. Installation must always
comply with applicable codes, standards, laws and
regulations. Adhere strictly to local, state and
national electrical and building codes. Comply with
regulations the Occupational Safety and Health
Administration (OSHA) has established. Also,
ensure that the generator is installed in accordance
with the manufacturer's instructions and
recommendations. Following proper installation, do
nothing that might alter a safe installation and
render the unit in noncompliance with the
aforementioned codes, standards, laws and
regulations.
• Keep a fire extinguisher near the generator at all
times. Extinguishers rated "ABC" by the National
Fire Protection Association are appropriate for use
on the standby electric system. Keep the
extinguisher properly charged and be familiar with
its use. Consult the local fire department with any
questions pertaining to fire extinguishers.
1.2.5— Explosion Hazards
•
Do not smoke around the generator. Wipe up any
fuel or oil spills immediately. Ensure that no
combustible materials are left in the generator
compartment, or on or near the generator, as FIRE
or EXPLOSION may result. Keep the area
surrounding the generator clean and free from
debris.
• Gaseous fluids such as natural gas and liquid
propane (LP) gas are extremely EXPLOSIVE.
Install the fuel supply system according to
applicable fuel-gas codes. Before placing the home
standby electric system into service, fuel system
lines must be properly purged and leak tested
according to applicable code. After installation,
inspect the fuel system periodically for leaks. No
leakage is permitted.
DANGER
Electrical backfeed. Use only approved switchgear to isolate
generator when electrical utility is the primary power
source. Failure to do so can result in generator damage
and could result in death or serious injury.
(000131)
3