Installation - Agilent Technologies Turbo-V 300 ICE Serie Manual De Instrucciones

Installation

WARNING! The Turbo-V controller is equipped with a 3-wire power cord and plug
(internationally approved) for user safety. Use this power cord and plug in
conjunction with a properly grounded power socket to avoid electrical shock.
High voltage developed in the controller can cause severe injury or death.
Before servicing the unit, disconnect the input power cable.
The Turbo-V controller can be used as a bench unit or a rack module, but it must
NOTE
be positioned so that free air can flow through the holes. Do not install or use
the controller in an environment exposed to atmospheric agents (rain, snow,
ice), dust, aggressive gases, or in explosive environments or those with a high
fire risk.
During operation, the following environmental conditions must be
respected:
To connect the controller to the pump use the specific cable supplied
with the controller. See the appendix "Technical Information" for
detailed Information about the above mentioned and the other
connections, and about the options installation.
Turbo-V 300 ICE Controller User Manual / 87-900-902-01 (M)
temperature: from 0 °C to +40 °C
relative humidity: 0 – 95 % (without conden-sation).
Instructions for Use

Installation

197/260
16