Installation
6
Installation
A
NOTICE!
The parking cooler may only be installed by qualified personnel from a
specialist company. The following information is intended for specialists who
are familiar with the guidelines and safety precautions to be applied.
6.1
Prescribed installation method
The compressor unit (fig. 1 1, page 3) is attached to the firm and straight rear
panel of the cab or by means of a firm fastening frame.
I
NOTE
The connection line (fig. 1 3, page 3) can only be installed after fitting the
evaporator unit and the compressor unit.
The SP950 auxiliary air conditioning unit with CoolAir SP950I rear panel
evaporator unit consists of the following components (fig. 1, page 3):
• CoolAir SP950C compressor unit (1)
• CoolAir SP950I rear panel evaporator unit (2) with connection line (3)
The SP950 auxiliary air conditioning unit with CoolAir SP950T roof evaporator
unit consists of the following components (fig. 1, page 3):
• CoolAir SP950C compressor unit (1)
• CoolAir SP950T roof evaporator unit (4) with connection line (3)
12
CoolAir SP950C
EN