Katun Canon C100 Guia De Inicio Rapido página 2

(A) Corona wire cleaner handle
(B) Front cover/handle
(C) Corona assembly
(D) Drum retainer
(E) OPC drum
(F) Waste toner compartment lid
(G) Drum cleaning blade
(H) Screen grid
(J) End block covers
(K) Corona wire positioning blocks
(L) Corona wire spring
Katun Rebuilding Instructions
for Canon C100, NP-1010/1020/6010 Drum Unit/Cartridges
Katun Rebuilding Kit Contents:
(1) OPC drum
(1) Drum cleaning blade
(1) Precut corona wire
(1) Corona wire spring
(3) Corona wire anchor screws
(1) Rebuilding instructions
Tools and Materials Recommended for Rebuilding Procedure:
• Phillips screwdrivers, #2 and #0
• Office equipment service vacuum
• True-flush side cutters
• Small flat-tip screwdriver
• Captive spring hook
• Clean cloths
• 99% pure isopropyl alcohol
(NOTE: All recommended tools and materials are available from Katun.)
Disassembly:
NOTE: Follow these instructions carefully. The quality and performance of the rebuilt 1010-series drum unit/cartridge will depend on
workmanship as well as the condition of the used drum unit/cartridge being rebuilt.
1. Pull the gray corona wire cleaner handle (A) outward approximately one inch (2.5 cm).