Festo DGE-ZR-RF Serie Instrucciones De Utilizacion página 56

DGE− −ZR−RF
Malfunction
Missing or
undefined
switching switching
functions
Jamming
Permitted
dynamics
not reached
Locking in"
at one
position
Vibrations
Motor speed
cannot be
transmitted transmitted
to product
56
Possible cause
Proximity sensor or cable
defective
Sensor support or switching lug
incorrectly fitted
Switching gap set incorrectly
Incorrect switch or incorrect
connection
Excessive dirt under toothed belt
Axis badly damaged due to crash
or similar
Outside the axis (e.g. drive
package including motor
mounting kit or external devices)
Incorrect toothed belt tensioning
e.g. due to belt damage
Long downtime
Axis overloaded
Dynamics too high
Incorrect arrangement of the
centre of gravity of the effective
load
External coupling on base stand
or in multi−axis system
Clamping hub spins
Toothed belt torn or teeth worn
Remedy
Fit new proximity sensor or replace
cable
Redo settings
Readjust
Use correct switch or connection
Repair cause and return product to
Festo
Return product to Festo
è
Instructions
Return product to Festo
Disappears after a start−up phase
Observe maximum loading values
If necessary, check modifications to
project planning
Shift centre of gravity
Eliminate interference
Check how the motor mounting kit
is fitted (coupling)
Return product to Festo
Festo DGE− −ZR−RF 0906d English