Installation And Removal Of The Base - Prexiso T.O.2 Manual De Usuario

4.5 Installation and Removal of the Base

Remove of the base
Installation of the
base
1. Turn the screw on knob a outward
using flat screw driver until it no more
limits position.
2. Turn knob a counter-clockwise,
a
holding the base with one hand and
take the main body of the instrument
off the base.
1. Turn the knob a counter-clockwise
until it reaches the position limit.
b
2. Make the positioning block b on the
main body of the instrument in line
c
with the notch c on the base and
install the main body onto the base as
shown.
3. Turn the knob a clockwise until it
reaches the position limit so that the
mark points downward.
4. Turn the screw until it can limit posi-
tion.
T.O.2 | 29