Parts Identification; Operating Your Dehumidifier; Set Unit Upright; Set Up Drain Hose - Dri-Eaz LGR i-Serie Manual Del Usuario

traffic though the drying chamber to a minimum. Place
your dehumidifier against a wall, away from obstructions,
and keep it away from anything that could block airflow
into and out of the unit. For more information about

PARTS IDENTIFICATION

FIG. A: FRONT
Control panel.
FIG. C: POWER AND PUMP
ATTACHMENT POINTS
AA battery compartment. Provides
power to HygroTrac wireless
transmitter when unit is not plugged in.

OPERATING YOUR DEHUMIDIFIER

Set unit upright

NOTICE: If you transport an i-Series dehumidifier in a
horizontal position, set it upright and let it stand for at
least 30 minutes before you turn it on. When the
machine is horizontal, the oil from the compressor flows
07-01674G 2013-01 Warranty 07-00420
Molded pocket
for cord storage.
Humid air inlet
(both sides).
Process (dehumidified)
air outlet. May be used
with standard 12" rigid
or layflat ducting.
Power cord socket.
creating an optimum drying environment, contact Dri-
Eaz at 800-932-3030.
FIG. B: REAR
Integrated handle.
Lower back panel. Remove
this panel to access the
pump for servicing.
FIG. D: PUMP ACCESS PANEL
Bottom of back
polyethylene housing.
Remove two bolts to
remove pump for cleaning.
into the refrigerant coils reducing the ability of the
dehumidifier to function. Letting the unit stand upright for
30 minutes allows the oil to flow back into the
compressor.

Set up drain hose

The i-Series condensate pump connects to a plastic
drainage hose that is located in the pocket on the back
3
Rugged rotomolded
housing resists dents
and scratches and is
easy to maintain.
Drain hose pocket.
Lower back panel. Remove the
five retaining screws to remove
pump for cleaning.
Dri-Eaz Products, Inc.