Ideal 61-497 Manual De Instrucciones página 8

5.7 LOG RATE
PRESS
DC
V
ENTER
LOG RATE
LOG
PRESS
RATE
CANCEL
The LOG RATE is the record rate of DATALOG. When blink cursor of
menu is LOG RATE, press the Enter button to enter LOG RATE mode.
Press the Up or Down button to select LOG RATE, then press the
Cancel button to exit.
The LOG RATE can be set from 0.5 to 600 seconds. See the below list:
0.5s / 1s / 10s / 30s / 60s / 120s / 180s / 240s / 300s / 360s / 480s / 600s
5.8 DATALOG
The datalog mode records the successive input values to memory and
recalls them from memory later. The maximum recorded records in
memory are 20000.
To use the DATALOG, when blink cursor of menu is DATALOG, press
the Enter button to enter DATALOG mode. In this mode, you can press
the Up or Down button to select START / VIEW to start DATALOG or
review the record data of memory.
When DATALOG is enabled, press ENTER to pause recording. Press
ENTER again to continue. When DATALOG is paused, the meter still
records the time. To stop the DATALOG, press CANCEL > 2sec.
DC
V
LOG RATE
LOG
RATE
PRESS
DC
V
LOG RATE
LOG
RATE
15
Auto Power Off
AUTOTEST
AC
V
RANGE HFR EBTER A-HOLD
DIGIT CANCEL P-HOLD
OFF
Wake-up the meter by switching the rotor or pressing any button.
Auto Backlight
The backlight is automatically turned on in dark environments.
AUTO
K
BUZZER
The meter beeps once for every valid key-press, and beeps twice for
every invalid key-press.
Power On Options
Press the button while turning the meter on from OFF position.
Cancel button : Clear all stored data
Range button : Display LCD test frame
Function button : Default °C / °F reading
HFR button : Display firmware version
A-HOLD button : Disable AUTO BACKLIT
20min
RANGE HFR EBTER A-HOLD
DIGIT CANCEL P-HOLD
V
AUTO
BACKLIT
AUTO
K
16