Servicing The Bidet Wand - Kohler K-3901 Guía De Instalación Y Cuidado

Spray Tip

Servicing the Bidet Wand

Servicing the Bidet Wand Spray Tip
NOTE: The bidet wand spray tip can become clogged with mineral deposits from the water. It should be
cleaned periodically. The length of time between each cleaning will depend upon water quality. If
performance is poor, the spray tip should be cleaned.
Select [settings].
Select [cleaning].
Select [manual clean].
Select [extend wand]. The bidet wand will deploy.
Manually clean the bidet wand.
Remove the bidet wand spray tip by inserting a small thin object into the hole on the underside of
the wand, pushing the spray tip up.
Inspect the spray tip. If there is mineral buildup in the spray tip, remove the minerals by soaking
the spray tip in a cleaning solution until the minerals are gone.
Remove any mineral deposits from the spray tip opening in the bidet wand.
Replace the spray tip if needed.
Reinstall the spray tip once it is clean or install a new spray tip. Make sure the tip is flush with the
surrounding surfaces on the wand. If the spray tip is not flush, it may be damaged or stick as the
wand retracts.
Select [close] when the spray tip has been reinstalled.
Select [home] to return to the main screen or [back] to return to the previous screen.
1212876-5-E
Bidet
Wand
Bidet
Light
12 Kohler Co.