Mounting Grip Rod; Installing The Grass Collection Box - Grizzly BRM 46-144 A-OHV Traducción Del Manual De Instrucciones Original

Cortacésped de gasolina
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 142

Mounting grip rod

Make sure that the Bowden cable
(
6) is not crushed during the
assembly of the grip handle.
Mounting the lower bars:
1. Remove the two star grip
screws (20) from the machine
housing (15).
2. Attach the ends of the lower
handlebars (4) to the machine
housing (15).
3. Screw the two lower handlebars
(4) tight with the enclosed star
grip screws (20) on the right
and left of the mounting on the
machine housing (15).
Mounting the upper grip:
4. Screw the upper grip (1) to the
right and left of the lower han-
dlebars (4) using the included
quick-release levers and nuts
(24).
5. Fold out the upper grip (1)
(small picture) and press the
locking lever (24) towards the
handlebar.
6. Fasten the Bowden cable (6)
using a cable clamp (5) to the
bottom handle (4).
Installing the Grass Collection
Box
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket:
1. Loosen the Phillips screw (30)
on the carrying handle (22).
2. Place the carrying handle (22)
on the upper side of the grass
collector (19) and screw it tight
with a Philips screw (30) from
below.
3. Push the grass collection box
rod (28) into the upper side of
the grass collection box (19)
and screw it tight with the two
Philips screws (29) from above.
4. Place the net of the grass col-
lection box into the groove on
the upper side of the grass col-
lection box (22). It will lock into
place.
5. Pull plastic loops (27) over bas-
ket rods.
Fixing the Grass Collection
Box onto the Equipment:
6. Lift up shock protection (21).
7. Hook the grass collection box
(19) into the mounting provided
for this (31) on the rear of the
equipment.
8. Release the impact protection
(21). It holds the grass collec-
tion box in position.
Dismantling/Empty out the
Grass Collection Box:
9. Lift the impact protection (21)
and remove the grass collection
box (19).
10. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.
GB
101

Publicidad

Tabla de contenido
loading

Tabla de contenido