Sanus SLF5 Manual De Instrucciones página 13

Tabla de contenido

Publicidad

3.
Drill pilot holes then remove the wall plate template
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32 in.) diameter drill bit.
4.
Install the wall plate
16
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
3
75 mm
(3 in.)
5.5 mm
(7/32 in.)
15
using four lag bolts
and washers
17
15
.
. Tighten all lag bolts only until they are pulled firmly against the wall plate.
19
4
17
19
16
13

Publicidad

Tabla de contenido
loading

Tabla de contenido