Display Assembly Wall Mount Instructions - Health O Meter Professional 349KLX Manual De Instrucciones

DISPLAY ASSEMBLY WALL MOUNT INSTRUCTIONS

Display Assembly Wall Mounting Instructions (Refer to Figure 4 on page 11)
Caution: When wall mounting the display assembly, ensure that the
mounting location is free of electrical lines, gas pipes, and other safety
hazards. Ensure that wall is of construction that can support the display
assembly.
Note:
Remote head can be mounted to a wall up to 6 feet (1.83 m) from the base or it can be
mounted on the display bracket (included) for placement on a table up to 6 feet (1.83 m) from
the base.
1. Position the display assembly on the wall, and carefully trace around the
display outline.
2. Mark a level horizontal line, ¾" (19 mm) below the top of the display outline.
3. Mark a vertical line 2-¼" (57.2 mm) from each side of the display outline.
4. Use the appropriate plastic or metal anchors for the type of wall construction.
5. At the horizontal and vertical intersection, carefully drill the appropriate size
hole.
6. Insert the anchors into the wall, and screw the two mounting screws into the
anchors. Adjust the screw head depth such that the screw heads protrude
1/8" (3.2 mm) from the wall.
Warning: Extending the screw heads beyond 1/8" (3.2 mm) can damage the
display assembly.
7. Position the display assembly mounting holes onto the mounting screws, and
carefully pull down on the display assembly to secure.
Required Parts
(1) Display assembly
(2) #8 Anchoring screws (4.2 mm nominal OD)
(2) Mounting anchors, compatible with wall construction
10