Setup / Battery / Transport; Optional Ac Adapter - Health O Meter Professional 349KLX Manual De Instrucciones

SETUP / BATTERY / TRANSPORT

Preparing the 349KLX Scale for Use
Replacing / Inserting Battery
1.
Unplug the AC adapter from the power source.
2. Remove the battery cover on the side of the display assembly by sliding the battery cover out
(see Figure 5 on page 13).
3. Replace or install the battery (Figure 6 on page 13).
Note: ®
Health o meter Professional recommends using an alkaline or lithium battery, rated for
130° F (54° C) operation. Do not use zinc-carbon battery.
4. Re-attach the battery cover to the display assembly.
Warning: If the scale will not be used for some time, remove the battery to avoid a safety
hazard. Disposal of battery must be performed in accordance with the prevailing
national, regional or local regulations which apply to you.

Optional AC Adapter

1. Remove the protective plastic film covering the display (the film says "FACTORY
CALIBRATED").
2. Place battery into the battery holder (see Figure 5 on page 13).
3. Connect the optional AC adapter into adapter jack on the display assembly (see Figure 2 on
page 8).
Warning: To avoid a safety hazard, use AC adapter model ADPT40.
4. Plug the scale's AC adapter into the power source.
5. Ensure all objects are removed from the scale's assembly, and then press the ON button to
power the scale on. The display will show "349", then "0.0" lb. Press the lb. /kg button to select
the weight mode (lb or kg).
6. When the AC adapter is disconnected from the scale, the scale will switch to battery power if
battery is installed.
Note: If the set up procedure failed, refer to the troubleshooting instructions. If the problem is
not corrected, refer to qualified service personnel.
12