Improved Sealing Effect And Overheat Protection; Shut Down Function When Vacuum Is Not Reached; Vacuum Package In A Canister - CASO DESIGN FastVac 4004 Manual Del Usaurio

► Clean and straighten the open end of the bag before sealing. Foreign matter or creases
on the bag may result in a faulty seal.
► Press the bag to expel excess air before vacuuming it. Too much air inside the bag may
result in a poor vacuum.
► If the food you're sealing has sharp edges (such as bones or shells) pack the edges
with kitchen paper to avoid tearing the bag
► We suggest you allow one minute of time in between sealing sessions to allow the
sealer to cool.
► When vacuum sealing liquid-based foods (such as soups or stew) freeze them first in a
baking pan or tempered dish before bagging and vacuum sealing them.
► Blanch vegetables by cooking them briefly in boiling water. Allow them to cool then
vacuum seal them in convenient portions.
► When vacuum sealing unfrozen food, allow at least two additional inches of bag length
for expansion while freezing. Place unfrozen meat or fish on a paper towel and vacuum
seal with the paper towel in the bag to absorb any extra moisture.
► Before storing foods such as tortillas, crepes or bread, use wax or parchment paper
between them to stack the pieces. This will make it easier to remove an individual piece,
reseal the rest and immediately replace them in the freezer.

18.3 Improved sealing effect and overheat protection

For best sealing effect, it is better to let the appliance cool down for 30 seconds before
using it again. Wipe out any excess liquid or food residue in the vacuum chamber after
each bag packaged. Using the seal function continuously without allowing 30 seconds rest
will cause overheating to take place: the first progress indicator blinks, the machine go into
cool down mode and cannot work. Please open lid and wait for 20 minutes for complete
cool down.

18.4 Shut down function when vacuum is not reached

If the required vacuum is not reached, the vacuum system will shut automatically after 60
seconds, in this situation, please check if the bag is leak, or not placed properly or any
other reasons.
Close the cover. Insert one end of the hose into the air intake and another end of the hose
into the center hole of the canister cover.
PLEASE NOTE
18.5 Vacuum package in a
Canister
Wipe canister cover, canister base and
ensure they are clean and dry.
Put the items into the canister and do not
fill up too full so that the cover can be in
good contact with the canister bowl rim.
43