Adjusting The Headrest - Play SAFE ONE Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
INSTRUCTIONS FOR USE

Adjusting the headrest

• The headrest has 7 positions. To select one of the positions pull the adjustment button,
found on the rear part of the backrest, and move the headrest to the required position
(fig.1).
• It will click when correctly fastened into place.
NOTE: make sure the headrest is not left between two positions.
Installing the Safe One in the vehicle (group l)
WARNING: to use the Safe One as a group l (9 to 18 kg) it is necessary to use
the safety harness and the padded protector.
• Place the Safe One on the seat of the vehicle, making sure that it is pressed firmly against
the backrest of the vehicle seat.
• Tighten the safety harness by pulling the end of the harness adjustment strap (fig.2).
• Insert the car seat belt into the belt slot in the backrest of the safety seat (fig.3).
• Pass both sections of the seat belt between the backrest and the upholstery (fig.4-5).
• Fasten the seat belt buckle (fig.6).
• Lastly, tighten the seat belt. First the abdominal section and then the diagonal one (fig.7).
• Loosen the safety harness. To do this press the central adjuster and pull both of the harness
straps.
• Open the harness buckle. Press the red central button, found on the buckle, and separate
the two sides.
• Place the child in the Safe One and fit the harness.
• Insert the two sides into the buckle, it will click when correctly fastened (fig.8).
• Pull the harness adjustment strap (fig.9) so it fits the child correctly (fig.10). Always check
that the shoulder straps are at the correct height for the child. The child's shoulders should
always be below the harness slots.
NOTE: Make sure that the straps are not twisted and that the upholstery does
not impede the movement or fitting of the seat belt.
WARNING: When installed as group I, the belt slot on the headrest should not
be used.
• To get the child out of the safety seat, press the harness adjustment button, and pull the two
shoulder straps.
• Unfasten the buckle and take the harness off the child.
• To take the Safe One off the vehicle seat, follow the same steps in reverse.
19

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido