MAG Welding torches
3.2 Emergency information
4 Putting into operation
4.1 Equipping the torch
1
1
Gas nozzle
2
Contact tip
Fig. 1
Type 61GD/610D
NOTE
Describes the risk of impairing work results or the risk that may result in
material damage to the equipment.
In case of emergency, immediately interrupt the following supplies:
• Power, Gas
Further measures can be found in the "Power supply" user manual or in the
documentation of further peripheral devices.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Cut off the gas supply.
• Pull the mains plug.
NOTE
• The MAG welding torches may only be put into operation by trained
personnel.
CAUTION
Risk of injury
Through-hole or puncture caused by electrode tip.
• Do not reach into the danger zone.
• Wear protective gloves.
2
3
Tip adaptor
4
Gas diffuser
3
4
5
Torch neck
4 Putting into operation
5
EN - 5