Feed In Wire; Handle Operating Elements; Trigger With Two-Position Function - Abicor Binzel RB/RP Serie Instructivo De Servicio

5 Handle operating elements

4.5 Feed in wire

5 Handle operating elements

5.1 Trigger with two-position function

6 Operation
EN - 8
NOTE
• Each time the wire is changed, make sure that the cutting point is free
of burrs.
1 Insert the wire in the wire feed unit as specified by the manufacturer.
2 Press the "Wire Jog" push-button at the wire feed unit until the wire comes
out of the contact tip.
NOTE
• As the MAG welding torch is integrated into a welding system, the
operating instructions of the welding components, such as power supply,
must be observed during operation.
Using a standard welding torch, the two-position mode of the trigger can be
activated.
1 Press the trigger on the handle and keep it pressed = welding is started.
2 Release the trigger = welding is stopped.
1 Open the shielding gas cylinder.
2 Switch on the power supply.
3 Setting the welding parameters.
4 Welding is started.
NOTE
• Hose assemblies containing PVC hoses will start leaking if the return
coolant temperature is exceeded. Make sure not to exceed a return
coolant temperature of 60°C.
MAG Welding torches