Abicor Binzel ABIMIG W Serie Instructivo De Servicio página 31

®
ABIMIG W
Fault
Torch neck gets too hot
No trigger function
Wire burned solid in the
contact tip
Irregular wire feed
Arc between the gas
nozzle and the workpiece
Erratic arc
Pore formation
Tab. 6
Troubleshooting
11 Disposal
BAL.0085 • 2017-03-02
Cause
Contact tip/collet not tightened
properly
Power fittings loose on the torch side
and to the workpiece
Coolant flow too low
Control lead interrupted/defective
Flow control in the coolant
recirculator has triggered
Wrong parameter setting
Contact tip worn out
Liner clogged

Contact tip and wire
aligned
Wrong contact pressure set on the
wire feeder unit
Spatter bridge between the contact
tip and the gas nozzle
Contact tip is not aligned to the wire
diameter or contact tip has failed
Wrong parameter setting
Wire guide unit worn out
Strong weld spatter build-up in the
gas nozzle
Insufficient or no gas coverage
Air current blows shielding gas away
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards
and guidelines.
Troubleshooting
Check and tighten
Check the cooling system
Check/repair
Check coolant level and top up, if
necessary
Check and correct setting
Replace
Clean in both directions with
compressed air. Replace if
necessary.
 are not
Replace contact tip
Correct as specified by the
manufacturer
Clean and spray the gas nozzle
interior
Check the contact tip and replace
Check and correct setting
Replace the wire guide.
Cleaning the wire guide
Correct the welding parameters
Use partitions to shield the welding
area
11 Disposal
EN - 15