Dascom Tally MIP480 Guia Del Usuario página 110

Command Sets
Function
Vertical Control
Line feed
Form feed
Advance paper n/180 inch (1 ≤ n ≤ 255)
Set line spacing to 1/8 inch
Set line spacing to n/180 inch (0 ≤ n ≤ 255)
Set line spacing to n/60 inch (0 ≤ n ≤ 127)
Set line spacing to 1/6 inch
Set line spacing to n/360 inch (0 ≤ n ≤ 255)
Tabulation
Horizontal tab execution
Set horizontal tabs
The values of n 1 to n k in this command are the ASCII values of
the print columns (at the current character width) at which tabs
are to be set.
(1 ≤ n ≤ 255) (1 ≤ k ≤ 32)
Move print position n/120 inch (for draft) (*1)
or n/180 inch (for letter) (*1) right from left margin
(n = n 1 + n 2 X 256)
Move print position n/120 (*1) inch (for draft)
or n/180 (*1) inch (for letter) left or right from the current
position
(n = n 1 + n 2 X 256)
Vertical tab execution
Set vertical tabs
The values of n 1 to n k in this command are the
ASCII values of the lines (at the current line
spacing) at which tabs are to be set.
(1 ≤ n ≤ 255) (1 ≤ k ≤ 16)
Move to dot line (d 1 + d 2 X 256)/360 (*2) inch
n 1 = 2, n 2 = 0
(0 ≤ d 1 ≤ 255) (0 ≤ d 2 ≤ 127)
Vertical relative move by (d 1 + d 2 X 256)/360 (*2) inch ESC ( v (n 1 ) (n 2 ) (d 1 ) (d 2 )
n 1 = 2, n 2 = 0
(0 ≤ d 1 ≤ 255) (0 ≤ d 2 ≤ 127)
–32768 ≤ d 1 + d 2 X 256 ≤ 32768
*1 The value depends on the pitch set by the ESC (U command.
*2 The value depends on the pitch set by the ESC (U command. The default is 1/360 inch.
C-16
Command
LF
FF
ESC J (n)
ESC 0
ESC 3 (n)
ESC A (n)
ESC 2
ESC + (n)
HT
ESC D (n 1 ) ... (n k ) NUL
ESC $ (n 1 ) (n 2 )
ESC \ (n 1 ) (n 2 )
VT
ESC B (n 1 ) ... (n k ) NUL
ESC ( V (n 1 ) (n 2 ) (d 1 ) (d 2 )