Glass Cleaning; Fireplace Surface Cleaning - Dimplex DF2426GB Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
Figure 7
Back
Ledge
Rear
Tab
side section
8.
replace the log set by
inserting the front edge of the
log set and push down on
the rear edge of the ember
bed until it snaps into place
(Figure 7).
! NOTE: Ensure the log set is
installed tightly under the back
ledge to prevent light leakage.
9.
replace glass assembly.
14

glass Cleaning

The front glass is cleaned in
the factory during the assembly
Log
Ember
operation. During shipment,
Bed
installation, handling, etc., the
front glass may collect dust
particles, these can be removed
by dusting lightly with a clean dry
Front
Edge
cloth.
To remove fingerprints or other
marks, the glass can be cleaned
with a damp cloth. The glass
should be completely dried with
a lint free cloth to prevent water
spots. To prevent scratching,
do not use abrasive cleaners or
spray liquids on the glass surface.
Fireplace Surface
Cleaning
To remove fingerprints or other
marks, the exterior finish can be
cleaned with a damp cloth with
a mild detergent. The surface
should be completely dried with
a lint free cloth to prevent water
spots.
www.dimplex.com

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Df2426ssDf2550

Tabla de contenido