Site Selection And Preparation - Dimplex DF2426GB Manual Del Propietário

Site Selection and Preparation

This section provides instructions
for selecting a location and
preparing the site to install the
fireplace into your Dimplex mantel
surround.
1. select a suitable location that
is not susceptible to moisture
and is away from drapes,
furniture and high traffic.
2. For ease of electrical hook
up you may wish to locate
the fireplace near an existing
outlet.
! NOTE: A 15 Amp, 120
Volt circuit is required. A
dedicated circuit is preferred
but not essential in all cases.
A dedicated circuit will be
required if, after installation,
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
3. store the fireplace in a safe
dry and dust free location.
! NOTE: The dimensions of the
fireplace are 26 inches (660.5
mm) wide X 18 ⅞ inches
(479.5 mm) high X 9 ¼ inches
(235 mm) deep. The fireplace
does not require any additional
venting.
7