Metrohm 765 Dosimat Instrucciones Para El Uso página 41

Information byte 2:
Bit
4.2.8 DOS
Selection of standard mode DOS. The standard parameters (depending on the exchange
unit) are loaded into the working memory. If the exchange unit is not filled, filling is
executed.
4.2.9 DIS R
Selection of standard mode DIS R. The standard parameters (depending on the
exchange unit) are loaded into the working memory. If the exchange unit is not filled,
filling is executed.
4.2.10 DIS C
Selection of standard mode DIS C. The standard parameters (depending on the
exchange unit) are loaded into the working memory. If the exchange unit is not filled,
filling is executed.
4.2.11 PIP
Selection of standard mode PIP. The standard parameters (depending on the exchange
unit) are loaded into the working memory. If the exchange unit is not filled, filling is
executed.
4.2.12 DIL
Selection of standard mode DIL. The standard parameters (depending on the exchange
unit) are loaded into the working memory. If the exchange unit is not filled, filling is
executed.
4.2.13 MDO
Selection of mode DOS without changing the actual parameters in the working memory.
No filling of the exchange unit.
4.2.14 MDR
Selection of mode DIS R without changing the actual parameters in the working memory.
No filling of the exchange unit.
765 Dosimat
Function
0 1= Wrong command code
1 1 = Parameter corrected to its limit value
2 1 = Repeat command in the READY state
3 1 = Cylinder empty
4 1 = Remote control on
5 1 = Data transfer on (send RS232 on)
6 Reserve
Mode DOS, not live
Mode DIS R, not live
Mode DIS C, not live
Mode PIP, not live
Mode DIL, not live
Mode DOS with previous parameters, not live
Mode DIS R with previous parameters, not live
4.2 Control commands
37