Operation - Amana AP125HD Manual De Instrucciones

Operation

Note: Wait for 24 hours to turn on air conditioner if the unit has been tilted for any
reason. This is for the oils and the coolants to settle and level off.
1. Wait for 3 minutes before restarting the unit after a normal shut down so as to complete the
compressor cycle.
2. Use an 115v 15 amp outlet for the air conditioner. Do not use any other electrical appliances
on this outlet or you may trip the fuse. Use a dedicated outlet for this air conditioner.
3. Do not place the air conditioner in direct sunlight or close to any heating appliances.
(ex. baseboard heaters, stoves, etc.)
4. Operate on a flat surface only.
5. Keep the unit free of any obstructions such as drapes, curtains, blinds, etc.
6. Keep unit at least 1 foot away from the wall.
7. Check and clean the filter once every week to get the highest efficiency.
Note: Do not use unit without filter.
8. If the unit is not being used for a long period of time, remove the plug from the water drain
pipe and drain out any condensed water.
When turning on the unit first time after plugging it into an electrical outlet the unit will start in a
low fan cool mode. The temperature read out on the LED will be the room temperature. When
turning on the unit in regular usage it will remember the last shut off setting.
English
(9)