Installation Instructions - Amprobe R-115S Manual Del Usaurio

INSTALLATION INSTRUCTIONS

REMCON Remote-Control Switching:
Connecting Relays in Circuits
When installing more than one relay, tag each
switch leg with the relay number so that circuits can
be easily identified when finish wiring is done.
Note: For generic instructions of connecting relays in
the circuits see page 6.
1. Rough in service and branch circuits. Mount boxes
at the fixture locations to be controlled. Run high-
voltage wiring to each box. Break out knockouts
to be used for relay. All uncontrolled outlets are
wired in conventional fashion. REMCON relays
should not be mounted at this stage of wiring to
avoid any possibility of damage.
2. Mount plater ring MB-1 for switch supports at all
switch locations. Each MB-1 can accommodate up
to 3 switches. Mount the MB-1 horizontally.
3. Run #18 3-conductor low-voltage thermoplastic
wire from each relay location to its switch
location. Use a staple gun and simply staple-as-
you-go. Leave a 12-inch loop on both switches
and relay ends. Wire should be installed in
workmanlike manner so that other trades will
not injure the thermoplastic covering.
4