Introduction; Applications - Amprobe R-115S Manual Del Usaurio

INTRODUCTION

• Each REMCON relay, unlike any other low
voltage relay, has a built-in transformer for
unit control. Each relay in the system operates
independently and has no effect on other relays.
You can economically install as little as one relay
and operate it with as many switches desired.
• Only 6 volts on switch legs. That means no
Romex or armored cable* to pull; just light,
pliable #18 wire. *Where code permits
• Simpler wiring. No need to wire back to a
separate, low voltage transformer. You simply
connect the low-voltage wires to the terminals.
• Silent operation. Low relay noise level permits
installation of relay, right at the fixture. No
need to mount in a remote location.
• Relay cannot burn out if low voltage switch
legs are shorted.
• R-115S and RC-120S are solid state relays.

APPLICATIONS

• 3-way (or more) switching of a light
• Individual switch controls
• Converting closet lights to operate from door
jamb switches
• Outside lights with indoor switching control
2