Safety Information - Amprobe R-115S Manual Del Usaurio

SAFETY INFORMATION

� CAUTION
• Improper connection of power leads will result
in permanent damage to the relay. Re-check
your wiring before turning on AC power!
• To control relay, use only REMCON momentary-
contact switch or equivalent. If any old
REMCON control switches containing a light
bulb exist in the installation, the light bulb
must be removed from these switches, or
improper relay operation will result!
• The R-115S cannot be used to replace the R-4115.
• Do not exceed ratings of 6.5 AMPS AC resistive,
tungsten or ballast load, or 1/4 HP motor load.
• Do not install relay in a location where the
temperature may exceed 104 °F (40 °C).
• Incorrect hook-up can result in an electrical
hazard.
• Note: If there is more than one relay on a circuit,
the relays must all be the same type (i.e. all
R-115 or all R-115S). They cannot be intermixed
because of the difference in control currents.
• Improper connection of power leads will result
in permanent damage. Re-check your wiring
before turning on AC power to line.
3