Amprobe R-115S Manual Del Usaurio página 13

REMCON Low-Voltage Closet-Light Switching
1. Mount box at closet fixture location and run
120-volt line box. Break out knockout for later
insertion of relay.
2. Drill hole in door jamb to accommodate switch.
String 2-conductor #18 wire from door jamb and
pull through knockout in box. Connect 2 wires
projecting from cylinder of relay to the 2-conductor
#18 wire and insert relay through knockout.
3. Connect the 2-conductor #18 wire to switch.
Insert switch in door jamb and secure with screws.
4. Connect relay to 120-volt line (Shown in diagram).
1
3
7
2
4