Clean The Instrument; Measure The Temperature Of The Heating Block - Hach DRB 200 Manual Del Usuario

To configure a user temperature program:
1. Select a user temperature program using the keys.
2. Push Prog to enter programming mode.
3. Select a 4-character name for the program. Push the left key to
change the character. Push the right arrow key to move the cursor to
the next position. Push OK to save the change.
4. Push or hold down the up and down arrow keys to set the
temperature (37 to 165 °C). Push OK to save the change.
5. Push or hold down the up and down arrow keys to set the time (0 to
480 minutes). Push OK to save the change.
6. Push OK to save the program.
Maintenance
W A R N I N G
Multiple hazards. Do not disassemble the instrument for maintenance or service.
If the internal components must be cleaned or repaired, contact the
manufacturer.
C A U T I O N
Personal injury hazard. Only qualified personnel should conduct the tasks
described in this section of the manual.

Clean the instrument

Keep the instrument clean to get continuous and accurate operation.
W A R N I N G
Fire Hazard. Do not use flammable agents to clean the instrument.
C A U T I O N
Burn Hazard. Do not clean the instrument when it is hot.
N O T I C E
To prevent instrument damage, do not use cleaning agents such as turpentine,
acetone or similar products to clean the instrument including the display.
1. Turn the instrument off and disconnect the power cord.
2. When the instrument is cool, clean the surface of the instrument with
a soft, moist cloth and a weak soap solution. Make sure that no water
gets into the instrument.
If the liquid in a sample cell spills or a sample cell breaks:
1. Turn the instrument off and disconnect the power cord.
2. Let the temperature of the heating block(s) and sample cells
decrease until cool.
3. Remove the liquid with a pipette. Do not let the liquid touch skin.
4. Move the liquid to the correct disposal.
5. Remove broken glass using tweezers. Remove any remaining liquid
on the instrument. Do not let the liquid touch skin.

Measure the temperature of the heating block

Measure the temperature of the heating block to make sure that the
temperature shown on the display is correct.
The temperature shown on the display is the temperature in a closed
sample cell that is filled with a liquid. While the temperature of the
heating block is increasing, the temperature of the heating block, near
the heater, may be greater than the temperature shown on the display.
Tools needed:
• Sample cell (2275800)
• Glycerol (anhydrous), 5 mL
• Thermometer, stem-type, calibrated for 95 to170 °C (203 to 338 °F)
To measure the temperature of the heating block:
1. Fill a clean, empty sample cell with glycerol that is at room
temperature.
2. Put the thermometer in the sample cell until the thermometer touches
the bottom of the sample cell.
3. Make sure that the level of the glycerol is 56 mm ± 0.5 mm (2.20 in. ±
0.02 in.) from the bottom of the sample cell when the thermometer is
in the sample cell.
English 9