Instructions For Electrical Connection; Cables, Extensions And Plugs; Removing Sawdust Generated During Use - Kunzle & Tasin Bona Scorpion DCS Manual De Funcionamento

Commencing Operation (Cont.)

Instructions for electrical connection

This machine only operates
with the voltage and
frequency shown on the
machine data plate. Before
connecting the cable to the
power supply ensure the
correct voltage and frequency
are available.

Cables, extensions and plugs

Only use approved cables. The maximum recommended cable length is 10m; for greater lengths use cables with a larger cross-
section.
MACHINE WITH 230V~50Hz MOTOR
For machines with a 230-240V~50Hz motor (EU), a HO5VV-F 3x1.5mm
with an approved SCHUKO 2P+E 16A 200÷250V plug.

Removing sawdust generated during use

Sawdust can ignite spontaneously and cause injury or damage.
Replace the dust bag when it is 1/3 full into metal containers
which are located outside the building. DO NOT re-use the dust
DO NOT expose the machine to rain. This machine is
intended for dry use only. Keep the machine in a dry
building and DO NOT use it in damp or wet places.
If the machine is not connected correctly to the electricity
network, death due to electrocution may occur. To
prevent electric shocks always use a grounded three
wire electrical system. For maximum protection against
electric shocks use a circuit protected with a differential
cut-out switch.
Tampering with the grounding plug in any way may result
in death from electrocution. DO NOT cut, remove or
break the grounding plug. If the socket does not match
the plug consult a qualified electrician.
Do not use the machine if the switch does not open and
close.
Using the machine with unsuitable cable cross-sections and/or excessively long cables
may cause injury or damage to people or objects.
The machine must never be moved using its cable and the cable must never be pulled when
disconnecting from the socket.
Keep the cable away from sources of heat, oil and sharp edges.
HAR-approved power supply cable must be used along
2
bag: use a new replacement each time.
Never leave the dust bag unattended
when it contains sawdust.
Bona Scorpion DCS Manual
If the machine is used with
a damaged plug or power
supply cable, death may
occur from electrocution.
If cables or plugs are worn
or damaged in any way,
have them replaced by the
manufacturer or certified
machine repair center in order
to prevent risks to safety.
11 11
EN