How To Assemble Your Ceiling Fan - Fanimation LEVON CUSTOM MAD7912 Serie Manual Del Usuario

1. Remove the hanger ball portion from the downrod
/hanger ball assembly by loosening the set screw
in the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and
hanger ball for reinstallation in Step 6 (Figure 1).
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4 (Figure 2).
3. The fan comes with black and white wires. Separate
and untwist the two wires and route them through the
downrod. Loosen the two setscrews in the downrod
support. Install downrod into coupler. Align the clevis
pin holes in the downrod with the holes in the downrod
support. (Figure 3)
4. Install the clevis pin, hairpin clip and tighten set
screws. The clevis pin and hair pin clip must be
properly installed to prevent the set screws from
working loose. (Figure 4)
WARNING
It is critical that the clevis screw in the downrod support is
properly installed and the setscrews and nuts are securely
tightened. Failure to verify that the clevis screw, nuts, hairpin
clip and setscrews are properly installed could result in the fan
falling.

How to Assemble Your Ceiling Fan

Downrod
Set Screw
Hairpin
Clip
Downrod
Set Screw
w/Hex Nut
7
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Black and White wires
Set Screws
Figure 3
Hairpin
Clip
Figure 4