Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: This step is applicable after the necessary wiring
is completed.
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Remove the two shoulder screws in the hanger
bracket. Align holes in the canopy with holes in the
hanger bracket and securely attach canopy using the two
shoulder screws from the hanger bracket. (Figure 1)
2. Securely attach and tighten the canopy screw cover
o
v
r e
h t
e
s
h
o
u
d l
r e
c s
the keyslot twist-lock feature. (Figure 2)
Assembling and Mounting the Fan Blades
Assembling and Mounting the Fan Blades
1. Lay the side of the blade holder on a flat surface
with the inside of the blade holder facing up.
Assemble the blade to the blade holder with the
carriage nuts, flat washer, and screws. Make sure
that the blades are fully seated against the blade
holders. Tighten screws with screwdriver provided,
don't over-tighten. (Figure 1)
NOTE: You will find the fan blade set packed in its own
carton and the blade holders and hardware bag in the
fan box.
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
Installing the Canopy Housing
e r
w
s
n i
h t
e
h
a
n
g
r e
b
a r
k c
CAUTION
t e
u
i t
z i l
n i
g
Blade Holder
11
Figure 1
Figure 2
Figure 1
HARDWARE USED:
3/16 -24
SCREWS
FLAT WASHER
3/16 -24 CARRIAGE
HEAD NUT
Blade
x 24
x 24
x 24
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
