Start-Up; Outdoor Sensor - ADE WS 1703 Instrucciones De Operación

Start-up

‚ Proceed in the order specified below and first
insert the batteries into the outdoor sensor.
Only then can the weather station function
without flaws.
‚ Do not use rechargeable batteries, since their
voltage is too low (only 1.2 V instead of 1.5 V).
This affects, among other things, the precision
of the measurements.
‚ Where possible, use alkaline rather than zinc-
carbon batteries. Alkaline batteries last longer,
especially at low outdoor temperatures.

Outdoor sensor

1. Remove the battery compartment cover on the rear
side of the outdoor sensor by pressing with a little force
on the imprinted arrow. Slide the battery compartment
cover in the direction of the arrow, away from the
outdoor sensor.
2. Insert 2 batteries of type LR03 (AAA)/1.5 V as depicted
on the bottom of the battery compartment. Pay
attention to the correct polarity of the batteries (+/-).
3. Slide the battery compartment cover back into place
on the outdoor sensor.
Weather Station with Wireless Outdoor Sensor WS 1703
53