PEERLESS SA752PU Instalación Y Montaje página 11

VESA 200 x 200 or VESA 200 x 100 Mounting Pattern (Continued)
Align one screen bracket with one set of screen
3-2
mounting holes.
Begin with the shortest length screw, hand thread
screw through multi-washer and screen brackets
into screen as shown. Screw must make at least
three full turns into the mounting hole and fi t snug
into place. Do not over tighten. If screw cannot
make three full turns into the screen, select a longer
length screw from the baffl ed fastener pack. Center
screen brackets vertically and tighten screws.
NOTE: For screens with a bump-out or recessed
back, spacer may be used. Spacer goes between
screen bracket and screen.
Slide universal adapter bracket to the opposite side
3-3
and align second screen bracket with second set of
screen mounting holes.
Hand thread screws through multi-washer, screen
bracket, and spacer if used, into screen as shown.
Tighten all screws.
Center screen brackets horizontally on back of screen as shown in fi gure 3.3.
3-4
Tighten two 1/4-20 x 1.25" screws. Reinstall four 1/4-20 x .6" screws using 5 mm allen wrench (I) into fi xed-stop
position 1 as shown in fi gure 3.4.
fi g. 3.3
MULTI-
WASHER
SCREEN
BRACKET
MULTI-WASHER
1/4-20 x 1.25" SCREWS
fi g. 3.4
FIXED STOP POSITION #1 WITH
1/4-20 x .6" SCREWS
11 of 58
ISSUED: 10-30-09 SHEET #: 095-9297-4 10-01-10
SCREW
SCREEN
SCREW
SCREEN
SCREEN
BRACKET